Shrimp sampling method improves stocking process

Andrew J. Ray, M.S. Jeffrey M. Lotz, Ph.D. Jeffrey F. Brunson, M.S. John W. Leffler, Ph.D.

Variation in size can be due to nursery stocking density

sampling
Calculations based on multiple samples of 200 shrimp taken at the nursery stage can lead to more accurate stocking in the grow-out phase.

Accurate estimation of the number of shrimp in a culture unit is critical for managers to administer appropriate feed rations and predict harvest size. If the population is underestimated, the animals will be underfed, leading to poor growth. If the system is overfed due to an overestimation of the population, unnecessary nutrients can cause oxygen depletion and toxic inorganic nitrogen accumulation, in addition to significant economic losses caused by wasted feed.

To estimate the population size of a growout system, an accurate approximation of the number of shrimp stocked must first be made. One of the advantages to operating a nursery prior to the grow-out cycle is that the number of shrimp can be reassessed between the two stages. The mean weight of multiple groups of shrimp is commonly used to determine the quantity of shrimp, by weight, needed to stock at a particular density. However, knowing the number of samples needed to overcome nursery size variability and arrive at a statistically sound approximation of the weight needed can substantially increase accuracy.

Shrimp sampling method

To arrive at an accurate estimate of shrimp weight, a statistics-based sequential sampling method is routinely used at the Gulf Coast Research Laboratory in Mississippi, USA, and the Waddell Mariculture Center in South Carolina, USA. Groups of animals from all areas of the nursery are collected, and care is taken to avoid crowding animals in nets.

Approximately 200 animals are included in each sample. Samples are then carefully weighed, and the exact numbers of shrimp are counted. The sample weight and number of shrimp in each sample are recorded in an electronic spreadsheet. The formulas used to calculate each subsequent value are preprogrammed into the spreadsheet before sampling begins. A completed example spreadsheet file is depicted in Table 1.

Ray, Typical organization for a spreadsheet, Table 1

Sample NumberWeight (g)Number of ShrimpShrimp/gCumulative Mean Shrimp/gStandard DeviationStandard ErrorConfidence BoundConfidence Bound CB/Mean
1215.62771.285
2202.62701.3331.3090.0340.0240.3040.232
3200.12741.3691.3290.0420.0240.1050.079
4206.82000.9671.2380.1840.0920.2930.237
5204.12581.2641.2440.1600.072
0.1990.160
6200.02521.2601.2460.1430.0580.1500.121
7205.32261.1011.2260.1420.0540.1310.107
8201.82621.2981.2350.1340.0470.1120.091
9203.42831.3911.2520.1360.0450.1040.083
10207.23061.4771.2750.1460.0460.1050.082
11214.92871.3361.2800.1400.0420.0940.073
12206.22671.2951.2810.1340.0390.0850.066
13202.72511.2381.2780.1280.0360.0780.061
14203.52601.2781.2780.1230.0330.0710.056
15217.42911.3391.2820.1200.0310.0660.052
Table 1. Typical organization for a spreadsheet used to monitor confidence bounds around the mean.

From the number of shrimp in each sample and the weight of that sample, a shrimp per gram value is calculated. In the following column, a cumulative mean shrimp per gram value is calculated with each new sample. From that, standard deviation and standard error values are calculated as in equation 1 in Fig. 1. The standard error value is used in equation 2 to calculate the confidence bound (C.B.). The C.B. is then divided by the latest cumulative mean value to determine whether the limits of the C.B. are within 5 percent of the mean.

Error and confidence
Fig. 1: Error and confidence equations.

The t-value used in equation 2 (Fig. 1) to calculate the C.B. comes from a table of t-distributions typically found in statistics books. The value needed is from a two-tale t-distribution where α = 0.05. The t-value used depends on the number of samples weighed, where degrees of freedom = N-1. The t-values are presented in Table 2.

Ray, αT-values used to calculate confidence, Table 1

Degrees of FreedomT-Value (two-tale, α = 0.05
112.706
24.303
33.182
42.776
52.571
62.447
72.365
82.306
92.262
102.228
112.201
122.179
132.160
142.145
152.132
162.120
172.110
182.101
192.093
202.086
212.080
222.074
232.069
242.064
252.060
262.056
272.052
282.048
292.045
302.042
Table 2. αT-values used to calculate confidence bounds with equation 2.

When at least 10 samples have been measured, and the C.B.:mean ratio is 0.05 or less, that latest cumulative mean value is accepted. Shrimp can then be stocked by weight using equation 3 (Fig. 1), with the accuracy of the number of shrimp stocked within 5 percent (Fig. 2). For example, using the data in Table 1, if a system manager would like to stock 50,000 animals from the sampled nursery, 39,001.6 g of shrimp (50,000/1.282) are needed.

sampling
Fig. 2: The standard error and confidence bound/mean ratio values from Table 1 change with sequential sampling. As the ratio converges toward the desired level of probability, the mean shrimp weight falls within the confidence bound.

Size variability, stocking density

To assess whether variation in shrimp size at the end of a nursery phase can be attributed to nursery stocking density, the authors examined data from 15 recent nursery harvests at the Waddell Mariculture Center. They compared the coefficient of variation in the size of shrimp at the time of nursery harvest to the original stocking density of those respective nurseries.

Using regression analysis, it was determined that stocking density was a strong predictor of the coefficient of variation in shrimp weight. This finding implies that with higher stocking density comes greater size variability when nurseries are harvested.

Perspectives

By sampling a nursery system in the manner described, the statistical confidence bounds around the mean shrimp weight are monitored closely as samples are collected. This allows a system manager to arrive at a point in sampling where 95 percent confidence bounds around the mean are established.

This project demonstrated that the amount of variation in shrimp size can be a product of the nursery stocking density. This may be an important consideration in determining the number of shrimp that should be stocked into a nursery system.

Stocking shrimp of uniform size reduces the initial variability of growout systems. It should be evaluated whether this reduction in variability results in a decrease of size variability at the end of the production cycle.

(Editor’s Note: This article was originally published in the July/August 2011 print edition of the Global Aquaculture Advocate.)